Remove the lamp from the wing by sliding either left or right this depends on how it was fitted last, slide horizontally about 1.5cm and then ease the lamp body complete with lens from the wing.

Before removing the bulb from the lens take precautions to ensure the bulb complete with wire does not re-enter the wing cavity of its own volition. A piece of card slotted to facilitate the cable positioned between the wing and the bulb carrier will prevent such an event. Remove the bulb from the lens unit by turning the bulb carrier the bulb is a push fit. Note the positions of the two 'O' Rings which ensure a firm fit of both bulb carrier and lens unit against the wing.

When placing the unit back into the wing, place the moulded spring side into the wing first, gently push and the unit will snap back into place.

Albert Rowe