Drivers seat box with fire extinguisher insert – Part number B6 7 81 0127 - £25.05 + VAT (11/04)

Passenger seat box with non slip liner – Part number B6 7 81 0128 - £25.05 + VAT (11/04)

Parts in each kit

 

(Picture of storage box PICTURE 1)

The instructions give no details of what you are supposed to do with the 4 rivets and two brackets from each kit. I presume they are something to do with the fire extinguisher as this is mentioned in the part number for the front storage box. This is strange as both kits are the same; both have a curved recess in the box before inserting the liner as you can see in the photos.

T25 Torx bit or screwdriver to screw in rail screws

E12 Female Torx socket to remove front driver’s seat and passenger seat if yours is removable

Ratchet and small extension

 

 

(Picture of tools PICTURE 2)

Remove seat from car. If you have removable passenger seat see previous article or owners manual.

For driver’s seat and non removable passenger seat you will need an E12 female Torx socket to remove seat. To do this remove the four Torx bolts from the end of each seat rail. A short ratchet extension is useful to be able to reach it.

 

(Picture of seat removed from car PICTURE 3)

 

 

(Close up PICTURE 4)

 

Lay seat on its back and you will see four screw holes with four locator pins

 

 

(Picture of under side of seat PICTURE 5)

 

 

(Close up of screw hole and pins PICTURE 6)

 

Place each rail on the locator pins and screw down with a T25 Torx screwdriver bit (two screws per side).

 

 

(Picture of rail attached PICTURE 7)

Slide storage box on to rails.

 

 

(Picture of seat with box installed PICTURE 8)

Put seat back in car.

Job complete.